basvital.blogg.se

1. #Make menuconfig bbb driver install#
2. #Make menuconfig bbb driver drivers#
3. #Make menuconfig bbb driver driver#

Note 1: Often the log buffer is to small and the earliest messages may be missing from the information retrieved with dmesg. The House Build Back Better plan would result in an estimated net revenue increase of about 1 trillion, 107,000 fewer jobs, and on average less after-tax incomes for the top 80 percent of taxpayers over the long run. This takes about 5 minutes on a 500 MHz system. Learn more about the House Build Back Better Act, including the latest details and analysis of the 1.85 trillion budget reconciliation bill. After saving your configuration above (it is stored in the '.config' file) you have to build the dependencies for your chosen configuration. In Mainboard vendor select the vendor of your board. Another possibility is make xconfig for a graphical version of menuconfig, if you are running X.

#Make menuconfig bbb driver driver#

How Do i integrate the KSZ9897 linux driver into my BBB linux kernel 17 jul. ifconfig -a ls /sys /class /netĬat /sys /kernel /debug /gpio # GPIO information OR make nconfig (easier to navigate, uses ncurses) In that menu (which may look familiar, as other projects such as the Linux kernel or busybox use the same system), select at least the following options: Enter the Mainboard menu. h: KSZ9897 7-port Gigabit Ethernet switch driver lan9303driver. cat /proc /cmdlineĬat /sys /class /mtd /mtd */offset # Linux 4.1 and newer, see note 2. Typically one can use the following commands:ĭmesg # log buffer might be to small, see note 1. This contains everything you need to get a speedtouch.

#Make menuconfig bbb driver install#

/sources/meta-imx/meta-bsp/. News flash HOWTO made obsolete by speedbundle Go to the download page and install the speedbundle.

the FCC ID is very useful when searching for documentation, datasheets and internal photo's (to be able to distinguish used chips without having to open the casing). The Linux Kernel recipe for this example is linux-imx5.4.bb.

#Make menuconfig bbb driver drivers#

Device Drivers -> Misc devices -> <> Analog Devices Digital Potentiometers <> support I2C bus connection <> support SPI bus connection.

On WikiDevi lots of information can be found, e.g. Configure kernel with make menuconfig (alternatively use make xconfig or make qconfig) The ad525xdpot driver depends on CONFIGSPI or CONFIGI2C.